1. Unbox and connect the board to RS232 (COM) port. Here I’m using FTDI USB serial adaptor. Do not plug in the power yet.

 

2. Open your terminal program and set up as follows:
Baud rate: 115200
Data: 8bit
Parity: none
Stop: 1bit
Flow control: none.
Here I’m using Teraterm.

 

3. Plug in power.  You should see messages from your terminal program. Hooray! You’re ready to go!

arrow
arrow
    全站熱搜

    silentlain 發表在 痞客邦 留言(1) 人氣()